alive15
Member
Good afternoon to all,
I have a 1756-EN2TR PLC using studio 5000, along with a Kinetix 6500 (2094-EN02D-M01-S0) drive. This drive controls my infeed of a grinding wheel. When I run at our normal production speed, the drive faults out and the machine gets thrown into e-stop due to Inhibit M05 fault. The manual says "check safety input wiring and check safety devices". Our safety devices are good and wiring looks good also.
I only get this fault when I run at normal production speed, but now that I have slowed the speed down, it is running parts without faulting out. Does this point to an issue with my drive? What else can I check to troubleshoot this?
Thanks,
I have a 1756-EN2TR PLC using studio 5000, along with a Kinetix 6500 (2094-EN02D-M01-S0) drive. This drive controls my infeed of a grinding wheel. When I run at our normal production speed, the drive faults out and the machine gets thrown into e-stop due to Inhibit M05 fault. The manual says "check safety input wiring and check safety devices". Our safety devices are good and wiring looks good also.
I only get this fault when I run at normal production speed, but now that I have slowed the speed down, it is running parts without faulting out. Does this point to an issue with my drive? What else can I check to troubleshoot this?
Thanks,