cardosocea
Member
Hello,
I have a running system where I'm completing an overfill protection logic and noticed that one of my feedback inputs is configured as "Not Used", and doesn't change state when I apply a signal to the input. This is to be changed to Safety, but when I am about to apply, I get a notification that I'll lose connection to the module and I'm wondering if doing this change is something that will reboot the processor or not.
Is there anyone that had the same predicament before?
I have a running system where I'm completing an overfill protection logic and noticed that one of my feedback inputs is configured as "Not Used", and doesn't change state when I apply a signal to the input. This is to be changed to Safety, but when I am about to apply, I get a notification that I'll lose connection to the module and I'm wondering if doing this change is something that will reboot the processor or not.
Is there anyone that had the same predicament before?