Tpetie3509
Member
Hardware:
Micrologix 1100 & 1762-IF4 Analog Input Module
Problem:
I have one 4-20mA transmitter hooked up to I1:0, I am monitoring the current as it comes in while I adjust it. The transmitter is outputting a good 4-20mA range, however the input as it comes into the PLC will stop at around 11.5mA at a raw value of 17673.
I am using a 12VDC power supply as it is a 12V PLC and the transmitter is 10-30VDC.
I can't figure out what would be causing this unless I'm underpowered which doesn't make sense as the transmitter and PLC are rated for operation well within what I am using.
Thanks
Micrologix 1100 & 1762-IF4 Analog Input Module
Problem:
I have one 4-20mA transmitter hooked up to I1:0, I am monitoring the current as it comes in while I adjust it. The transmitter is outputting a good 4-20mA range, however the input as it comes into the PLC will stop at around 11.5mA at a raw value of 17673.
I am using a 12VDC power supply as it is a 12V PLC and the transmitter is 10-30VDC.
I can't figure out what would be causing this unless I'm underpowered which doesn't make sense as the transmitter and PLC are rated for operation well within what I am using.
Thanks