There is no configuration screen on my panelview 600 2711-T6C20. Is there a way I can do it from my program in panelbuilder32?? I need to be able to access config settings.
1. You can create a screen selector to go the the config screen and password protect it if you want.
2. Or if you would rather not have the configuration screen accesible from the Panelview you can reboot the Panelview. While it is on it Blue boot screen you will see numbers incrementing. When it hits 32, I think, a white box will appear in the bottom right corner. Press it until it goes away. You actually only have to press it once but it can be hard to hit. This will bring up the config screen
There is no configuration screen on my panelview 600 2711-T6C20. Is there a way I can do it from my program in panelbuilder32?? I need to be able to access config settings.
I don't know the 600 touch screen units, but on our 2700-B6 (both touch and keypad entry), any time the unit is on (fully booted), you press the left and right arrow key simutaniously to access the config screen. (Same with our 550 Panelviews.) Does the touch screen only units have the left and right arrow keys available on screen?
I don't know the 600 touch screen units, but on our 2700-B6 (both touch and keypad entry), any time the unit is on (fully booted), you press the left and right arrow key simutaniously to access the config screen. (Same with our 550 Panelviews.) Does the touch screen only units have the left and right arrow keys available on screen?
No, just goes to the config screen. Also should note that if you have password protection setup for the config screen pressing the white button does not bypass that. You still must enter your password