Mr.Robot
Member
Hi all,
Have couple of AB 1756-OB16D modules that are faulted, poss power surge, as soon as insert into backplane, pre-check tests start, initially OK indicator goes green, then constant red & brings communication to controller down.
Connected to controller using RSLogix 5000 over Ethernet.
Looking for a way through software/hardware to investigate this further & reset the modules to factory default if possible & start over.
Thanks in advance.
Have couple of AB 1756-OB16D modules that are faulted, poss power surge, as soon as insert into backplane, pre-check tests start, initially OK indicator goes green, then constant red & brings communication to controller down.
Connected to controller using RSLogix 5000 over Ethernet.
Looking for a way through software/hardware to investigate this further & reset the modules to factory default if possible & start over.
Thanks in advance.