Hi All
Our plant has just received its first compactlogix (1769-L30) PLC, in some new equipment, whereas the rest of the plant is SLC 500 or PLC5
We have tried to connect this beastly little thing to our existing ethernet network (via a 1761-NET-ENI module) without much success
I am adamant that we have used the net-eni setup utility program OK, as the module itself does appear in RSWHO (RSLinx) back at the workshop, but the processor icon itself is not displayed.
We are using channel 1 of the PLC, Baud Rate of 38400 with 2 stop bits as per the manual...We can also go online to this processor using our laptop through the same serial port...Ok, Ok we disconnect the net-eni first, then...
Anybody got any ideas
(particularly Ken )
Our plant has just received its first compactlogix (1769-L30) PLC, in some new equipment, whereas the rest of the plant is SLC 500 or PLC5
We have tried to connect this beastly little thing to our existing ethernet network (via a 1761-NET-ENI module) without much success
I am adamant that we have used the net-eni setup utility program OK, as the module itself does appear in RSWHO (RSLinx) back at the workshop, but the processor icon itself is not displayed.
We are using channel 1 of the PLC, Baud Rate of 38400 with 2 stop bits as per the manual...We can also go online to this processor using our laptop through the same serial port...Ok, Ok we disconnect the net-eni first, then...
Anybody got any ideas
(particularly Ken )