Johnny T
Member
I need to program a series 90 30 plc. I've never programmed GE Fanuc before but it's only a small change so it should be ok. What I need though is the programming lead...
Is it a lead that needs to be bought from the manufacturer or is it possible to make one. If so, does anyone have a pin out for one?
I've looked on the GE Fanuc website but there is loads of different types of PLC. Is there just one lead to program them all, or are there different ones.
Can anyone point me in the right direction? Either which lead I need to get the customer to buy or a pin out for a lead that will do the job.
PS. While I'm on the subject, was I right in telling the customer to buy VersaPro. That is the programming software isn't it?
Thanks for any light you can shed on this...
JT
Is it a lead that needs to be bought from the manufacturer or is it possible to make one. If so, does anyone have a pin out for one?
I've looked on the GE Fanuc website but there is loads of different types of PLC. Is there just one lead to program them all, or are there different ones.
Can anyone point me in the right direction? Either which lead I need to get the customer to buy or a pin out for a lead that will do the job.
PS. While I'm on the subject, was I right in telling the customer to buy VersaPro. That is the programming software isn't it?
Thanks for any light you can shed on this...
JT