1756-L55 ControlLogix5555 Controller
RSL5K v.12
I've got a simple PIDE Block with an input reference to the PV and an output reference from the CV.
When I turn the key from Run to Program then back in Run Mode, the CV of the PIDE block goes to "0%". I beleive I've got other PIDE blocks that their CV's don't go to "0%".
Note: I'm not downloading to the controller, just turning the key.
Any ideas on what settings/parameters that may cause the above?
Thanks!!
RSL5K v.12
I've got a simple PIDE Block with an input reference to the PV and an output reference from the CV.
When I turn the key from Run to Program then back in Run Mode, the CV of the PIDE block goes to "0%". I beleive I've got other PIDE blocks that their CV's don't go to "0%".
Note: I'm not downloading to the controller, just turning the key.
Any ideas on what settings/parameters that may cause the above?
Thanks!!