Steve_D
Member
Guys, I am trying to connect to an ATL610 autochangeover unit (but thats not important) it has an ethernet adaptor to talk TCP/ip. I will utimately be reading data out of it with my scada package.
My problem is that it seems to be set up correctly, i.e I can ping it, but I cant seem to read the data out. It has a webgui so by rights I should just put in the IP adress and subnet mask of 255.255.255.0 and open internet explorer, type in the adress and get "something".
Unfortunately it just sits there with a blank window, no failed to connect errors or cant find the page errors or anything.
Any ideas why this might be? Could there be security settings that let you connect but not display detail?
Thanks in advance
My problem is that it seems to be set up correctly, i.e I can ping it, but I cant seem to read the data out. It has a webgui so by rights I should just put in the IP adress and subnet mask of 255.255.255.0 and open internet explorer, type in the adress and get "something".
Unfortunately it just sits there with a blank window, no failed to connect errors or cant find the page errors or anything.
Any ideas why this might be? Could there be security settings that let you connect but not display detail?
Thanks in advance