Hello everyone,
Maybe this thread is a little different from what the forum usually talks about, but I hope someone can help me.
I'm going to work on a project where I'll communicate an Inyection Molding Machine (IMM) to a Siemens PC (SIMATIC IPC227D with OPC), the protocol the IMM has to exchange communication is Euromap 63, and the Euromap organization has a document where it explains how to do so, so the document states that you should use an ethernet cable and then use TCP/IP and then it explains how to access the information.
The problem is that I'm not too familiar with this, I know how to program and I'm not stranger to some programming lenguajes, so, if anyone can send me a little explanation on how to start, or a little example, I'll probably be good to go.
I attach the Euromap 63 document, to see if it helps anybody.
Hope you can help me, best regards
Juan
Maybe this thread is a little different from what the forum usually talks about, but I hope someone can help me.
I'm going to work on a project where I'll communicate an Inyection Molding Machine (IMM) to a Siemens PC (SIMATIC IPC227D with OPC), the protocol the IMM has to exchange communication is Euromap 63, and the Euromap organization has a document where it explains how to do so, so the document states that you should use an ethernet cable and then use TCP/IP and then it explains how to access the information.
The problem is that I'm not too familiar with this, I know how to program and I'm not stranger to some programming lenguajes, so, if anyone can send me a little explanation on how to start, or a little example, I'll probably be good to go.
I attach the Euromap 63 document, to see if it helps anybody.
Hope you can help me, best regards
Juan