Hello folks,
This question is regarding a ML 1200 with a single expansion module, 1762-IF2OF2 (2 channel in, 2 channel out analog module).
The system was working great right up until it stopped working (2009 to yesterday).
The Major Error Halt bit S:1/13 is set
Major Error S:6 = 179h
Error description: Expansion I/O module 1 generated an error
Normally I am not a "parts swapper" but I'm short on time, so I was thinking about doing just that. Thought I'd run it by the experts though. Any thoughts?
Thanks a bunch everyone!
Byron
This question is regarding a ML 1200 with a single expansion module, 1762-IF2OF2 (2 channel in, 2 channel out analog module).
The system was working great right up until it stopped working (2009 to yesterday).
The Major Error Halt bit S:1/13 is set
Major Error S:6 = 179h
Error description: Expansion I/O module 1 generated an error
Normally I am not a "parts swapper" but I'm short on time, so I was thinking about doing just that. Thought I'd run it by the experts though. Any thoughts?
Thanks a bunch everyone!
Byron