Hello Everyone!!!
I have been using CP1E-N40DR-D PLC for my project and during the initial run there were some junk values in the PLC devices , so i cleared all the memory areas and the issue was resolved. But after 2 weeks when i again started the PLC there were again some junk values in the memory areas.
So is there any solution so that these junk values don't get stored in memory areas without clearing the memory areas again and again.
Thank you!!!
I have been using CP1E-N40DR-D PLC for my project and during the initial run there were some junk values in the PLC devices , so i cleared all the memory areas and the issue was resolved. But after 2 weeks when i again started the PLC there were again some junk values in the memory areas.
So is there any solution so that these junk values don't get stored in memory areas without clearing the memory areas again and again.
Thank you!!!