Hello, it's posible to program a remote 5/04 cpu with the pass-thru metod?
This is my situation:
I have a running AB PLC with a 5/04 CPU, but I can't stablish communications with the RS-232 port (bad or disabled port, I don't know). So I create a pass-thru network with another 5/04 cpu like this:
I know the DH+ network is working (the green DH+ led is on and steady in both CPUs), and I can see the "Local" and "Remote" CPUs in RS-Linx, but when I try to get online with the "Remote" CPU, I get the message "DiagnosticStatus failed: 0x10". I can get online with the "Local" CPU with no problems.
I also tried changing the status bits "DH-485 Pass-Thru Disabled Bit" and "Monitor DH+ Active Node Table" without luck.
Any sugestions?
The DH+ cable is about 9 ft (3 meters).
I'm using RSLinx 2.42 and RSLogix 6.3 with Windows ME.
Thanks in advance
This is my situation:
I have a running AB PLC with a 5/04 CPU, but I can't stablish communications with the RS-232 port (bad or disabled port, I don't know). So I create a pass-thru network with another 5/04 cpu like this:
I know the DH+ network is working (the green DH+ led is on and steady in both CPUs), and I can see the "Local" and "Remote" CPUs in RS-Linx, but when I try to get online with the "Remote" CPU, I get the message "DiagnosticStatus failed: 0x10". I can get online with the "Local" CPU with no problems.
I also tried changing the status bits "DH-485 Pass-Thru Disabled Bit" and "Monitor DH+ Active Node Table" without luck.
Any sugestions?
The DH+ cable is about 9 ft (3 meters).
I'm using RSLinx 2.42 and RSLogix 6.3 with Windows ME.
Thanks in advance