naruto_yyc
Member
Hi,
I have some question relate with Omron servo drive
I am using CJ1W-NC271 position control unit for servo drive
In the CX-MOTION- NCF, I setup driver(R88D-KN04L-ML2) memory area on CIO 1025 as output, CIO 1125 as output
But how can I know which bit is for jog or speed command
where can I find manual for that?
Thanks
Kyle
I have some question relate with Omron servo drive
I am using CJ1W-NC271 position control unit for servo drive
In the CX-MOTION- NCF, I setup driver(R88D-KN04L-ML2) memory area on CIO 1025 as output, CIO 1125 as output
But how can I know which bit is for jog or speed command
where can I find manual for that?
Thanks
Kyle
Last edited: