Omron G5-ECT servo drive and CJ1W-NC482 problem

kumpa

Member
K
Join Date
Nov 2014
Location
Zagreb
Posts
2
I want to setup full control loop at G5 servo drive, but every time I set Full-control loop and power-up drive I get communication setting error. Any clue what could be problem?
 

Similar Topics

P
Citect SCADA (Aveva Plant SCADA) IO Device Setup with Omron NX/NS over Ethernet/IP
We are trying to set up a newer generation Omron PLC (NX/NS Series) with Citect / Aveva Plant SCADA using the Ethernet/IP CIP Protocol to read...
Replies
2
Views
404
plcplcplcplc
P
A
omron nt31c connect with ls plc
hi hello every one . i have a Omron nt31c hmi and i want to connect with ls plc XBC DR60SU via rs232 . do any one now how ?? secondly :i have...
Replies
1
Views
202
ali1122turk
A
X
Aveva Plant SCADA 2020 (Citect) communicate with Omron CJ2M using OMFINS3
Hi All, I aim to use Aveva Plant SCADA 2020 to read and write data from/to Omron CJ2M CPU35 PLC using OMFINS protocol. However I have Bad Data...
Replies
1
Views
741
plcplcplcplc
P
T
Cant' connect to omron C200H CPU01
I have a sysmac omron plc C200H CPU01,only the power led is ON,using CX-ONE programmer software, and connecting to the plc via Host link LK202-V1...
Replies
2
Views
727
tarik1978
T
B
Omron Sysmac Import Project and adding IO Link
I come from an AB background. My current job has a lot of Omron devices. We have a couple systems with NX102's with numerous IO link devices...
Replies
0
Views
668
bagged2drag
B
Back
Top Bottom