mac 40+ transfer mode

Press the two blue buttons on the right side simultaneously. Use the arrow keys to select transfer and press enter or F6. F5 will back up one screen. Press the blue buttons again to exit program mode.
 

Similar Topics

S
sysmac studio license transfer
Hi all, I am trying to transfer my sysmac studio license from my PC to my co-workers pc as he will be the tech installing our new system. The...
Replies
0
Views
1,544
srsicard3
S
C
transfer data from laptop to omron sysmac cj1m cpu11 by rs232 and omron cs1w cn118?
Hi everybody, I can't transfer data from laptop to omron sysmac cj1m cpu11. I use cable "omron cs1w-cn118" and Uport 1150 (RS232),I sure software...
Replies
0
Views
3,915
canh1108
C
M
Command over Ethernet/IP (Sysmac Studio and Automation direct GS20)
Hi, I have been trying to run drive via Sysmac studio. I can ping the drive. I can see the logic bits going on/off as per command. But, drive is...
2
Replies
21
Views
565
tarik1978
T
R
Progstop and progstart in sysmac studio
Good morning to everyone on the forum and happy new year. I'm trying to use the following functions in sysmac studio, because I need to enable one...
Replies
1
Views
327
IO_Rack
IO_Rack
F
Sysmac HMI
So, here's probably a silly one that I hope someone here knows. I am working with a SYSMAC NA5 HMI. (First time doing anything with Omron.) What...
Replies
1
Views
506
parky
P
Back
Top Bottom