My first work using Siemens TIA portal and I have a problem that I hope I can get some help with
I need to make a few changes in a program at a costumer, the program runs in a ET200S CPU and is made with TIA portal v11, so far so good.
I made a fresh TIA portal v11 installation with WinCC comfort and updated the installation with update 2.
When I try to open the program file i get a message that I need to install WinCC Basic or comfort v11 update 2, I am going a little bit in circles with this installation.
Can I choose to go all in and get the latest TIA portal, with all the bells and whistles and upgrade the program to a newer version ? or am I stuck with version 11?
Thanks
/Holm
I need to make a few changes in a program at a costumer, the program runs in a ET200S CPU and is made with TIA portal v11, so far so good.
I made a fresh TIA portal v11 installation with WinCC comfort and updated the installation with update 2.
When I try to open the program file i get a message that I need to install WinCC Basic or comfort v11 update 2, I am going a little bit in circles with this installation.
Can I choose to go all in and get the latest TIA portal, with all the bells and whistles and upgrade the program to a newer version ? or am I stuck with version 11?
Thanks
/Holm