widelto
Member
HI:
After three years my customer has changed his mind and he finally decided to use a motion control system instead of conventional analog system.
Please take a look at : http://www.plctalk.net/qanda/showthread.php?t=97080&highlight=1756-hyd02
I never quoted , I am no expert in hydraulics so I asked him about the following info:
Hydraulic pump model, pressure, accumulator if they have one, cylinder dimensions, he says he has a servo control valve . I am expecting for servo valve datasheet.
I would like to hear your suggestions about this new system and what other info I would need in order to fulfill this new job.
Is there any literature that I should be aware of about this new design.
Regards,
William
After three years my customer has changed his mind and he finally decided to use a motion control system instead of conventional analog system.
Please take a look at : http://www.plctalk.net/qanda/showthread.php?t=97080&highlight=1756-hyd02
I never quoted , I am no expert in hydraulics so I asked him about the following info:
Hydraulic pump model, pressure, accumulator if they have one, cylinder dimensions, he says he has a servo control valve . I am expecting for servo valve datasheet.
I would like to hear your suggestions about this new system and what other info I would need in order to fulfill this new job.
Is there any literature that I should be aware of about this new design.
Regards,
William