Hi guys:
I am trying to setup the trunk for one stratix 8000 switch port. Below is the commands I entered through putty:
- en
- configure t
- int F2/2
- switchport mode trunk
Everything looks fine, no error message.
Then I type command "do show int trunk" to verify, but found nothing is changed. Looks like the command not take effect.
Any idea? Precondition? Miss step?
I am trying to setup the trunk for one stratix 8000 switch port. Below is the commands I entered through putty:
- en
- configure t
- int F2/2
- switchport mode trunk
Everything looks fine, no error message.
Then I type command "do show int trunk" to verify, but found nothing is changed. Looks like the command not take effect.
Any idea? Precondition? Miss step?