irondesk40
Member
could someone take a look at the attached pdf file and explain what i may be doing wrong. I recieved a file from tech support to show a example of how to change the screens on the HMI based on the value that is present in a Register in a allen bradley plc. The file from tech support showed a reference for 4 page changes. I tried to go in and edit it by copying the last reference for changing to page 4 and copying it and then editing to show a page reference for page 5.
As can be seen from the attached pdf file a red question mark appeared. Could someone explain this? Also, is there any kind of file or docuement that explains how you would actually enter programming text and the correct format. I have searched the manual and the web and not had much luck.
Thanks
As can be seen from the attached pdf file a red question mark appeared. Could someone explain this? Also, is there any kind of file or docuement that explains how you would actually enter programming text and the correct format. I have searched the manual and the web and not had much luck.
Thanks