Im using wago in one of my application
The Configuration is as below
Im communicating with HMI on MODBUS RTU.
Now the problem im facing is as below.
My analog input address start from %IW2 to %IW5 ( im getting values)
Now when im forcing my digital input at address %IX6.0 (1st channel) chanel is energized but its not energizing my bit in software and same problem is with digital output.
My communication with HMI is also working.
Kindly send me the addresses for above configuration as soon as possible.
Regards
The Configuration is as below
750-841
PROGRAMMABLE FIELDBUS CONTROLLER
WAGO
750-430
8-CHANNEL DIGITAL INPUT MODULE, 24V DC
WAGO
750-530
8-CHANNEL DIGITAL OUTPUT MODULE, 24V DC
WAGO
750-455
4-CHANNEL ANALOG INPUT MODULE, 4-20mA
WAGO
750-650
Serial interface RS232
WAGO
750-600
END MODULE
WAGO
Im communicating with HMI on MODBUS RTU.
Now the problem im facing is as below.
My analog input address start from %IW2 to %IW5 ( im getting values)
Now when im forcing my digital input at address %IX6.0 (1st channel) chanel is energized but its not energizing my bit in software and same problem is with digital output.
My communication with HMI is also working.
Kindly send me the addresses for above configuration as soon as possible.
Regards