KGAccIL
Member
Good Afternoon,
I'm currently trying to upload a program from an old GE 90-30 CPU with a Windows 10 laptop that is running Proficy Machine Edition v9.5.
I'm able to successfully connect to the controller with my serial cable, but every time I try to upload the program the RUN light and the OK light on the power supply goes out. Luckily the PLC is still functional, as a simple power cycle restores it to its previous state, but further attempts to upload result in the same thing. Does anybody know why this is happening and how I can successfully upload the program from this device?
Some information regarding the controller:
CPU P/N: IC693CPU321K (embedded in 10-slot backplane)
Power supply: IC693PWR321
Input Modules (Slots 1-3,7): IC693MDL645
Output Modules (Slots 4-6): IC693MDL741
I'm currently trying to upload a program from an old GE 90-30 CPU with a Windows 10 laptop that is running Proficy Machine Edition v9.5.
I'm able to successfully connect to the controller with my serial cable, but every time I try to upload the program the RUN light and the OK light on the power supply goes out. Luckily the PLC is still functional, as a simple power cycle restores it to its previous state, but further attempts to upload result in the same thing. Does anybody know why this is happening and how I can successfully upload the program from this device?
Some information regarding the controller:
CPU P/N: IC693CPU321K (embedded in 10-slot backplane)
Power supply: IC693PWR321
Input Modules (Slots 1-3,7): IC693MDL645
Output Modules (Slots 4-6): IC693MDL741