Dear readers,
I'm having troubles with my OP15.
To put the panel in transfer mode, you press the esc-key, the arrow right and the arrow down-key at the same time, and then you apply the power.
Normally the panel displays "Ready for transfer".
But today, it said "$006 Transfer Fail-No : 0 Sts: 8"
I tried the same routine a few times, but with no result.
Has anyone seen this message before ? And what is the solution to
get it in transfer mode ?
Kind regards,
VDBSYS
I'm having troubles with my OP15.
To put the panel in transfer mode, you press the esc-key, the arrow right and the arrow down-key at the same time, and then you apply the power.
Normally the panel displays "Ready for transfer".
But today, it said "$006 Transfer Fail-No : 0 Sts: 8"
I tried the same routine a few times, but with no result.
Has anyone seen this message before ? And what is the solution to
get it in transfer mode ?
Kind regards,
VDBSYS