FactoryTalktotheHand
Member
Have a job coming up where I'm using a bunch of Turck TBEN-L4-16DXP modules. They say they're configurable as inputs or outputs. I've downloaded the "sample code" from turck which is basically just a bunch of configured modules and no code. PLC is a CompactLogix 5069-L306ER.
I see an input assembly and an output assembly, and I've looked in the manual and correlated the I/O points with the assembly arrays. I have a few of these modules where I want to do half input and half output. So I'm wondering if there's any configuration I have to do to the Block I/O module itself. I can't find any information from Turck as regards that specific question. Do I just use the Output Assembly addresses for outputs and use the Input Assembly addresses for inputs and that's it? Or is there some special configuration software from Turck I need to set which channel is an input and which is an output?
I see an input assembly and an output assembly, and I've looked in the manual and correlated the I/O points with the assembly arrays. I have a few of these modules where I want to do half input and half output. So I'm wondering if there's any configuration I have to do to the Block I/O module itself. I can't find any information from Turck as regards that specific question. Do I just use the Output Assembly addresses for outputs and use the Input Assembly addresses for inputs and that's it? Or is there some special configuration software from Turck I need to set which channel is an input and which is an output?