Hi there, very much new to AB Drives / Drives in general.
Driving a pump with SMC Flex Drive Rating: Pump (5-135) Revision 6.008.
Currently the drive parameters indicate:
Option Input 1 = Stop Option
Stop Input = Coast
Stop Time = 120
Stopping with this mode is causing issues as the back-pressure is causing the pump to stop instantly and hammering on the check valve.
The manual states that there are 'Soft Stop' and 'Pump Stop' modes, however I cant seem to find where I would set this?
(150-um008_-en-p.pdf pg14)
Driving a pump with SMC Flex Drive Rating: Pump (5-135) Revision 6.008.
Currently the drive parameters indicate:
Option Input 1 = Stop Option
Stop Input = Coast
Stop Time = 120
Stopping with this mode is causing issues as the back-pressure is causing the pump to stop instantly and hammering on the check valve.
The manual states that there are 'Soft Stop' and 'Pump Stop' modes, however I cant seem to find where I would set this?
(150-um008_-en-p.pdf pg14)
Attachments
Last edited: