TonysControls
Member
So the quick and short of the situation is that I designed an axle press that was sent to one of my company's other facilities. That facility just implemented a local network that is on 11.11.41.XXX. The plc for the press was on 11.11.41.11. I am trying to change the IP from a distance and I used RSLinx to do so by remoting into a coworkers computer. The thing is I changed the IP on the device in RSLinx and now I cannot connect to the PLC and it has the red x.
The IP it was: 11.11.41.11 default gateway: 11.11.41.1
IP I assigned new: 11.11.40.60 (what IT gave me)
I changed the IP but forgot to change the default gateway before I clicked OK and now the device isn't at either IP.
I don't know if it is not showing up because the default gateway doesn't match the IP or what. Any help would be greatly appreciated.
The IP it was: 11.11.41.11 default gateway: 11.11.41.1
IP I assigned new: 11.11.40.60 (what IT gave me)
I changed the IP but forgot to change the default gateway before I clicked OK and now the device isn't at either IP.
I don't know if it is not showing up because the default gateway doesn't match the IP or what. Any help would be greatly appreciated.