I_Automation
Lifetime Supporting Member
Doing a remote online with a customer on a 1756-L62 (NOT "S"!) in RemoteRun mode. Project is ver16.04
To reset faults the easiest way is put in Program then back to Run.
However multiple tries got a popup that the processor received my command to change but has not. Had to have the customer flip the key switch.
Never encountered this before.
Does anyone know why this would happen?
Is there a fix?
To reset faults the easiest way is put in Program then back to Run.
However multiple tries got a popup that the processor received my command to change but has not. Had to have the customer flip the key switch.
Never encountered this before.
Does anyone know why this would happen?
Is there a fix?