Ken Schiebel
Member
- Join Date
- Feb 2003
- Posts
- 2
Hi,
I need to make or obtain a PLC2 cable that can be used for old A.I. software. It converts serial 9 pin directly to 15 pin D-Sub on PLC2. Ones I have seen are powered cables. Does anyone have a pinout, parts list/diagram of this cable? OR Do you know where to buy a relatively cheap one? Is there another un-powered one that will do this job?
Thanks,
Ken.
I need to make or obtain a PLC2 cable that can be used for old A.I. software. It converts serial 9 pin directly to 15 pin D-Sub on PLC2. Ones I have seen are powered cables. Does anyone have a pinout, parts list/diagram of this cable? OR Do you know where to buy a relatively cheap one? Is there another un-powered one that will do this job?
Thanks,
Ken.