Ian762
Member
Hello,
I am using a Digi One IAP and CompactLogix PLC to read some Modbus registers from a Kohler Generator. Things are working, except when I want to read some of the higher numbered registers, i.e. anything over 24599. In order to get to the full range of registers, I need to use PLC2 Unprotected Reads, however the documentation from the Digi One website does not show an example of how to do so. It just says to put in the address direct, but this is not accepted by Studio 5k as a valid Source Element.
Anyone have experience with this?
-Thanks
(I saw someone posted this a few years ago, however there was no solution.)
I am using a Digi One IAP and CompactLogix PLC to read some Modbus registers from a Kohler Generator. Things are working, except when I want to read some of the higher numbered registers, i.e. anything over 24599. In order to get to the full range of registers, I need to use PLC2 Unprotected Reads, however the documentation from the Digi One website does not show an example of how to do so. It just says to put in the address direct, but this is not accepted by Studio 5k as a valid Source Element.
Anyone have experience with this?
-Thanks
(I saw someone posted this a few years ago, however there was no solution.)