Hey all,
Having some issues with communication between a (Studio 5000 v. 29.01) 5380 CompactLogix, with dual Ethernet ports, and two PowerFlex 525 drives (v. 5.001). They are communicating through a hub.
I'm able to ping IP's and see the devices through Linx Classic, and I've even reset the drives and ran the Startup Wizard in CCW, but the PLC is still showing them as "module not configured".
I had issues with a PanelView Plus 6 1000, but that just needed the latest firmware to work (which it does now).
Am I missing something obvious/sipmle? I know it's a new controller, so not all the bugs are known/have fixes, but I've set up drives before with no issues on RSLogix5000 (would normally use generic ETHERNET-MODULE, but this time 'round, I had to use the actual PowerFlex 525 module).
Any help would be appreciated.
Having some issues with communication between a (Studio 5000 v. 29.01) 5380 CompactLogix, with dual Ethernet ports, and two PowerFlex 525 drives (v. 5.001). They are communicating through a hub.
I'm able to ping IP's and see the devices through Linx Classic, and I've even reset the drives and ran the Startup Wizard in CCW, but the PLC is still showing them as "module not configured".
I had issues with a PanelView Plus 6 1000, but that just needed the latest firmware to work (which it does now).
Am I missing something obvious/sipmle? I know it's a new controller, so not all the bugs are known/have fixes, but I've set up drives before with no issues on RSLogix5000 (would normally use generic ETHERNET-MODULE, but this time 'round, I had to use the actual PowerFlex 525 module).
Any help would be appreciated.
Last edited: