plccontrols
Member
Hello,
I am having a problem trying to update the firmware in a brand new Compactlogix controller 1769-L33ER. I continually get the message "target device is not in the proper mode to accept an update". I have set the prog/run switch to prog, and the SD card is unlocked. I have set the ethernet address using the BootP-DHCP server and subsequently disabled bootp/dhcp successfully. I can see the node in Rslinx and Rslogix 5000, and I can ping the address successfully. I have tried updating through both RSlogix and the Controlflash utility with the same result. These are the 2 failures from the log:
08/25/12 14:15:07 [FAILURE] Transfer: Error #11006: Service cannot be performed while object is in current state.
GS=0x0C
08/25/12 14:16:26 [FAILURE] Transfer: File = C:\Program Files\ControlFLASH\0001\000E\006B\PN-138317.der, Block = 1.
Is there some simple thing I'm missing? Some obscure, check box somewhere? Speaking of check boxes, the one that reads "Restrict communications except through selected slots" is unchecked. Any ideas/help would be greatly appreciated. Thanks.
I am having a problem trying to update the firmware in a brand new Compactlogix controller 1769-L33ER. I continually get the message "target device is not in the proper mode to accept an update". I have set the prog/run switch to prog, and the SD card is unlocked. I have set the ethernet address using the BootP-DHCP server and subsequently disabled bootp/dhcp successfully. I can see the node in Rslinx and Rslogix 5000, and I can ping the address successfully. I have tried updating through both RSlogix and the Controlflash utility with the same result. These are the 2 failures from the log:
08/25/12 14:15:07 [FAILURE] Transfer: Error #11006: Service cannot be performed while object is in current state.
GS=0x0C
08/25/12 14:16:26 [FAILURE] Transfer: File = C:\Program Files\ControlFLASH\0001\000E\006B\PN-138317.der, Block = 1.
Is there some simple thing I'm missing? Some obscure, check box somewhere? Speaking of check boxes, the one that reads "Restrict communications except through selected slots" is unchecked. Any ideas/help would be greatly appreciated. Thanks.