panic mode
Member
Hi everyone,
I was wondering if anyone was using PowerMAC from Atlas Copco.
I need pinout of the XS0, XS1 and XS2 connectors (Harting).
The XS0 is 3-phase power input (it should be 6-pin connector).
The other two are part of the safety circuit ("I/O group connectors").
Atlas is unable to provide better documentation than attached sample.
They say that once we receive units, there should be some printed
documentation that might be in better shape. The thing is I don't
have time for this, I need info ASAP because delivery for those
products is already way behind schedule...
Thanx,
panic mode
I was wondering if anyone was using PowerMAC from Atlas Copco.
I need pinout of the XS0, XS1 and XS2 connectors (Harting).
The XS0 is 3-phase power input (it should be 6-pin connector).
The other two are part of the safety circuit ("I/O group connectors").
Atlas is unable to provide better documentation than attached sample.
They say that once we receive units, there should be some printed
documentation that might be in better shape. The thing is I don't
have time for this, I need info ASAP because delivery for those
products is already way behind schedule...
Thanx,
panic mode