I need to add a NJ CPU to an existing network made of CJ2 sharing data by Ethernet/IP data links, and cannot get any information in manuals on how to make such a configuration . Is there any documentation around detailing the setup on NJ and/or CJ sides or someone done already and willing to share details? Thanks in advance
Ethernet data link between CJ2 and NJ series plc
- Thread starter CX_Luigi
- Start date
tarik1978
Member
Here is also some general information on EtherNet/IP Datalinks.
https://www.myomron.com/index.php?action=kb&article=1416
Regards,
https://www.myomron.com/index.php?action=kb&article=1416
Regards,
Similar Topics
Hey all, I have seen references to Data Link products in here before and looked up this as a potential solution to a job I have comming up. This...
Hello
I have a s7-1200 and I would like to read the tags present in this controller with my controllogix controller. The two controllers don't use...
Hello Everyone,
Does anyone have any suggestions or experince with a message board that could read a tag from a PLC, or have a PLC send a...
When E300 powered off, the ethernet device tag data stayed at last know state, for example, fault bit is still Off, ready bit is still ON, status...
Hi Guys,
I am trying to read data from Omron CP2E CPU from my Mitsubishi RJ71EN71 with Simple CPU Communication Function.
Suppose it was using...