rosiebean
Guest
R
I am trying to create a specific MSG command on an AB PLC5/40C15. I am basically doing what this knowledgebase article does:
http://domino.automation.rockwell.c...1ACF376E5B2E7B9F85256CA3006AF59B?OpenDocument
I want to send a MSG command on a ControlNet network to a ControlLogix gateway, and have the ControlLogix Gateway route my message to the destination node. To do this, I am selecting a multihop message (in RSLogix5), and on the multihop screen I input the destination node and destination Link ID. I have a ControlNet sniffer and I can see the packet go out, but the ControlLogix gateway rejects the address.
Is there some setup I must do to send to an RSlogix Address?
Any help would be appreciated, I am tired of banging my head on the keyboard.
http://domino.automation.rockwell.c...1ACF376E5B2E7B9F85256CA3006AF59B?OpenDocument
I want to send a MSG command on a ControlNet network to a ControlLogix gateway, and have the ControlLogix Gateway route my message to the destination node. To do this, I am selecting a multihop message (in RSLogix5), and on the multihop screen I input the destination node and destination Link ID. I have a ControlNet sniffer and I can see the packet go out, but the ControlLogix gateway rejects the address.
Is there some setup I must do to send to an RSlogix Address?
Any help would be appreciated, I am tired of banging my head on the keyboard.