Hi All,
I'm trying to connect a 1734-232ASC to a ViewMarq overhead display and I cannot figure this out for some reason.
I have the baud rate set as 19200 as they recommend along with parity, stop bits set to 1 and data bits set to 8 as they recommend. I have the tx from the card wired to the rx on the display, the rx on the card wired to the tx on the display, and the signal ground wired. The display is also set to the same.
When I trigger a send in the logic the tx on the card flashes but the display does not update and the rx on the card does not flash. The receive record also does not update in the tags.
I am including the delimiter $R in the module configuration and have tried adding this into the string, adding quotes, removing quotes, .etc.
Any help is appreciated!
Thanks!
I'm trying to connect a 1734-232ASC to a ViewMarq overhead display and I cannot figure this out for some reason.
I have the baud rate set as 19200 as they recommend along with parity, stop bits set to 1 and data bits set to 8 as they recommend. I have the tx from the card wired to the rx on the display, the rx on the card wired to the tx on the display, and the signal ground wired. The display is also set to the same.
When I trigger a send in the logic the tx on the card flashes but the display does not update and the rx on the card does not flash. The receive record also does not update in the tags.
I am including the delimiter $R in the module configuration and have tried adding this into the string, adding quotes, removing quotes, .etc.
Any help is appreciated!
Thanks!