Hi All,
I have two PV900 I would like to swap, ones screen is dead/dying.
from Ser-F Rev C(dying screen) >to> Ser-D Rev S
obviously the PVA cant be directly swapped as its not the same rev/ser
i tried just to make sure and it said incompatible pva file.
i do not have panelbuilder32 at the moment and using the winfp to get the files in and out
I assume i can open the pva in PB32 and re-set the versions, then transfer to the older working screen?
but before i spend the $ on it...
Is there a way to change these without buying the panelbuilder32 software?
thanks all.
I have two PV900 I would like to swap, ones screen is dead/dying.
from Ser-F Rev C(dying screen) >to> Ser-D Rev S
obviously the PVA cant be directly swapped as its not the same rev/ser
i tried just to make sure and it said incompatible pva file.
i do not have panelbuilder32 at the moment and using the winfp to get the files in and out
I assume i can open the pva in PB32 and re-set the versions, then transfer to the older working screen?
but before i spend the $ on it...
Is there a way to change these without buying the panelbuilder32 software?
thanks all.