ronny_resistor
Member
I have a 755 Drive with a Single Incremental Encoder Module.
I want to have the drive running on one encoder channel (A).
I hooked all the wires up to my encoder and set the bits in word 1 such that BIT#1 is a 1 (A-Channel only) I also set Bit #4 as Single ended.
I ran the motor and my feedback error (PAR 641) Shows 52.456 RPM
On the encoder MMI i see no feedback on the MMI when the motor is running
Any one have a Flashlight and illuminate what I am doing wrong ??
Thank you
I want to have the drive running on one encoder channel (A).
I hooked all the wires up to my encoder and set the bits in word 1 such that BIT#1 is a 1 (A-Channel only) I also set Bit #4 as Single ended.
I ran the motor and my feedback error (PAR 641) Shows 52.456 RPM
On the encoder MMI i see no feedback on the MMI when the motor is running
Any one have a Flashlight and illuminate what I am doing wrong ??
Thank you