Hi all,
I’m seeing a Workstation at node10 when I open the Routing Table, these are off the ENET card and have node numbers instead of IP addressed. I can right click and edit the node number etc but if I try to add a workstation I can only choose IP address. This is a relatively old system from approximately 2005.
I’m just wondering what the Workstation is. They aren’t DH+ nodes.
The control Logix gateway is a bridge between approximately 12 SLC505s and 3 SLC504s so just allowing MSG instructions between different networks. The DH+ PLCs don’t route out to the Ethernet/IP network. But the Ethernet PLCs use MultiHop msg instructions to msg the DH+ PLCs
Thanks for any help
I’m seeing a Workstation at node10 when I open the Routing Table, these are off the ENET card and have node numbers instead of IP addressed. I can right click and edit the node number etc but if I try to add a workstation I can only choose IP address. This is a relatively old system from approximately 2005.
I’m just wondering what the Workstation is. They aren’t DH+ nodes.
The control Logix gateway is a bridge between approximately 12 SLC505s and 3 SLC504s so just allowing MSG instructions between different networks. The DH+ PLCs don’t route out to the Ethernet/IP network. But the Ethernet PLCs use MultiHop msg instructions to msg the DH+ PLCs
Thanks for any help