Hello Everyone,
I'm trying to communicate with the SLC500 through Serial DF1 and I'm having some difficulties:
1st: I didn't quite get the difference between the Half Duplex and Full Duplex mode - When do i use one and when do i use the other? How do i know which one I'm using? I'm communicating through RS232.
2nd: I'm trying to implement CRC for communication, and I can't figure out what does this algorithm supposed to get me - It seems to converge on 0xFFFF when I have enough bits. I've attached the algorithm I found on the Serial DF1 manual (DF1 Protocol and Command Set Reference Manual)
Any help will be greatly appreciated!
Thank You
Nitay
I'm trying to communicate with the SLC500 through Serial DF1 and I'm having some difficulties:
1st: I didn't quite get the difference between the Half Duplex and Full Duplex mode - When do i use one and when do i use the other? How do i know which one I'm using? I'm communicating through RS232.
2nd: I'm trying to implement CRC for communication, and I can't figure out what does this algorithm supposed to get me - It seems to converge on 0xFFFF when I have enough bits. I've attached the algorithm I found on the Serial DF1 manual (DF1 Protocol and Command Set Reference Manual)
Any help will be greatly appreciated!
Thank You
Nitay