TimD
Lifetime Supporting Member
Hello,
I have an Automation Direct Modbus-to-Ethernet Gateway on the same netrwork as an AB NET-ENI Ethernet-to-Serial device.
The Modbus has one slave, a Flow Meter, data is coming in fine to the Gateway.
The ENI has a routing table configured with IP of Modbus GW and written into ROM of the ENI.
The ML1500 has a MSG block, (500 CPU Read) with node address as 45 (IP/Route of Modbus GW in ENI Table)
Unfortunately, I can't map my destination address as an AB standard, like N7:0 ... The AD GW has simple addresses like 0,1,2 etc, which obviously, I can't compile/download because of errors.
Anyone ever have to do this... and get it to work?
Any help appreciated.
Thanks,
Tim
I have an Automation Direct Modbus-to-Ethernet Gateway on the same netrwork as an AB NET-ENI Ethernet-to-Serial device.
The Modbus has one slave, a Flow Meter, data is coming in fine to the Gateway.
The ENI has a routing table configured with IP of Modbus GW and written into ROM of the ENI.
The ML1500 has a MSG block, (500 CPU Read) with node address as 45 (IP/Route of Modbus GW in ENI Table)
Unfortunately, I can't map my destination address as an AB standard, like N7:0 ... The AD GW has simple addresses like 0,1,2 etc, which obviously, I can't compile/download because of errors.
Anyone ever have to do this... and get it to work?
Any help appreciated.
Thanks,
Tim