AD SureServo "axis and a half" application

Norml

Member
N
Join Date
Nov 2006
Location
Maine
Posts
212
Hi guys,

I have a simple (I think) application involving 2 SureServo SVA-2040 drives. What I want to do is to control the master servo with a 0-10V analog signal and have the slave follow the master using electronic gearing. My question is can I use the pulse output from the master to drive the slave without using anything else such as a PLC or separate encoder?
 

Similar Topics

T
Is anyone familiar with AD SureServo PCS digital input position commands?
I am experimenting with a very simple program for testing purposes and not getting any movement from the servo motor. The attached program...
Replies
6
Views
1,797
ThreatLevelMidnight
T
T
Cable for Micrologix controller to AD Sureservo
I need to connect my ML1200 to a sureservo drive for modbus communication. Sureservo uses an IEEE 1394 connector. At the moment, I am not seeing...
2
Replies
23
Views
4,650
roxusa
R
T
Wiring limit switch to SureServo drive
For our system using a sureservo drive with Ziplink module, we have a limit switch that will be our "Home Sensor." Should the limit switch be...
Replies
1
Views
1,076
DarrylR
D
R
SureServo DI
Anyone work with Sureservo from Automation Direct? My question concerns the Digital Inputs DI 1-8. I am communicating Modbus and using the upper...
Replies
1
Views
1,624
gclshortt
gclshortt
R
Micrologix to Sureservo
I am working on different ways I can set up a Modbus topology for the comm's. I have 2 different cables from AD that can go to the drives, One is...
Replies
9
Views
1,939
roxusa
R
Back
Top Bottom