Slurryman
Member
I turn to the PLC gurus. We are running grout plants using the Melsec A series PLC's. The A2Ncpu is obsolete and no software. Is there a device to connect to extract data from a AD59/AD59MEM printer cable. I need so help...
AD59/AD59MEM Card
- Thread starter Slurryman
- Start date
http://www.plctalk.net/qanda/showthread.php?t=39286
This link may help you out in finding the cable and software.
Regards,
This link may help you out in finding the cable and software.
Regards,
Similar Topics
Hi,
We have been facing a issue with SCADAPack 474. Configuration is like below.
RTU 474 + 6103 PS + 5606 IO Mix Module + 5414 DI Module
Only...
I have a 120V relay, 120V DI card and a analog input. I was wanting to know if i could put a 24V DI and well as a 120V DI card on the same plc...
Hi everyone.
I'm trying to read values from a Loadcell with a 2080-TC card.
I know the 2080-TC is a thermocouple card but it reads millivolts that...
Omron AD081-V1 Analog Input Card
Offset & Gain Adjustment
Entering Adjustment Mode
1. Set the input card in adjustment mode (Turn ON Dip SW No-1)...
Hi All,
Has any of you tried to change the IP Gateway of the PLC (of course, essentially of the ENBT card), while in a redundant configuration...