Alarm messages with analog value

IvanGusha

Member
I
Join Date
Aug 2009
Location
Bor
Posts
2
Hello,

I'm new to Protool. How i can setup alarm messages if i have analog value tag? For example i wanna have alarm message if value of temperature is over 70.In attachment is screenshot of area pointers.
PostGetAttachment.aspx
 

Similar Topics

F
FT View SE Local Station - Alarm Messages show up in summary but not log
Migrating v8 FT View SE to v13, had to export tags because after v10 the configuration is no longer supported. Imported tags to new Tag Alarm...
Replies
1
Views
514
FordTruckMan
F
K
Factorytalk Alarm Messages not updating.
Hello everyone, I am dealing with something annoying and excruciatingly basic that I am just ready to cry. I have updated some alarm messages in...
Replies
6
Views
938
slick_william
S
L
How to tie alarm messages with fault codes from Servo Drive
I am new to programming rockwell and could use some help. I am using compact logix controller with an Ethernet IP Servo Drive. The servo has 400+...
Replies
13
Views
3,136
janner_10
J
K
PV+ Alarm Messages Disappearing
On one of our older machines I've upgraded an old pv 600 to a pv+7 standard 600. I'm using bit trigger alarms from a slc 5/05 to an alarm banner I...
Replies
5
Views
2,280
77nomad
7
T
Panelview 800 Alarm Triggers/Messages
Has anyone had any luck programming these? Source plc is a MicroLogix 1400 via ethernet. The tag referenced is a bit and alarm type is a bit set...
Replies
6
Views
4,124
maruciocruz
M
Back
Top Bottom