Phil Melore
Administrator
Hi Folks,
Generally I don't do this, but I've been trying to help Jasper from South Africa make a post to the forum. My support has been unsuccessful. bawling
So, please consider this a proxy post for him.
----
Jaspers question:
I have 7 AB Micrologix PLC's networked on DH485.
Does factory link support this network? I have to tie in to an existing scada setup.
-----
If you want to be a good samaritan and help him, you can email him at:
[email protected]
Since we should always keep the posts online, please cut/paste your email to him and cut/paste his replies here. Alot of work but I'm sure he would be grateful... and the community will learn as well.
If you're into internet pc support, he says " I have tried from desktop nt4.0 internet explorer v6, also from laptop with XP and IE6.0. Cookies are enabled. No firewall. I have also tried via Dial-up 56k modem instead of isdn - same result."
Generally I don't do this, but I've been trying to help Jasper from South Africa make a post to the forum. My support has been unsuccessful. bawling
So, please consider this a proxy post for him.
----
Jaspers question:
I have 7 AB Micrologix PLC's networked on DH485.
Does factory link support this network? I have to tie in to an existing scada setup.
-----
If you want to be a good samaritan and help him, you can email him at:
[email protected]
Since we should always keep the posts online, please cut/paste your email to him and cut/paste his replies here. Alot of work but I'm sure he would be grateful... and the community will learn as well.
If you're into internet pc support, he says " I have tried from desktop nt4.0 internet explorer v6, also from laptop with XP and IE6.0. Cookies are enabled. No firewall. I have also tried via Dial-up 56k modem instead of isdn - same result."
Last edited: