Hey Everyone,
I'm trying to communicate to an external device using ASCII Read and Write commands with RSLogix 5000. I need to Write an ASCII command to get the device to start spitting out an ASCII output, then I need to Read that output.
The termination of my ASCII string is <cr><lf> but I'm not certain how or where to configure this in RSLogix.
I've attached the sample program for review if anyone can give me some ideas.
I'm trying to communicate to an external device using ASCII Read and Write commands with RSLogix 5000. I need to Write an ASCII command to get the device to start spitting out an ASCII output, then I need to Read that output.
The termination of my ASCII string is <cr><lf> but I'm not certain how or where to configure this in RSLogix.
I've attached the sample program for review if anyone can give me some ideas.