Beijer E 1071 HMI

[Benyamin]

Hello,
Can somebody tell me how to Upload and Download program from Beijer 1071 Panel Operator/HMI to a CF Card directly without E-Designer, since I don't have one.
But if the E-Designer is a must to have, I will purchase it and please tell me the steps on how to Upload and Download.
Thank you very much in advance.

Best Regards,
Benyamin

 

[Ronnie Sullivan]

You can download and upload to a usb stick.
It has a usb slot.
You need to set the dip switches on the back
From memory, dipswitch 1 to on

 

[parky]

If I remember correctly to back up you really need E-Designer, however, there is a way. power down the HMI, select dip switch 1 to on (I think) then re-boot, it will come up with a screen allowing upload/download from memory card. The card needs to be configured with directories & must be FAT32. I have never uploaded only downloaded so don't know if you can, the file will be a dat file so cannot be edited. the best way (assuming no password) is to use E-designer to upload the project then you can export it to a DAT file & put it onto a flash or USB card.
If I remember correctly, if you plug a clean card into the HMI & wait for a while it will configure the directories for you.
It can take a little while to recognize the card so be patient, it will briefly show a message. Also if it does not respond, try removing the card & re-insert.