janner_10
Lifetime Supporting Member
Sadly I am in the unfortunate position to try and get an old FX0s-10MR-ES talking to a Beijer ix-T4A over serial.
This is my first use of either of these pieces of software.
SO I have set up the MELSEC FX Driver in the panel, using COM2 and I am using the SC-09 Beijer cable between the two devices.
The cable is good as I can download to the PLC, however, the screen does not want to talk to the PLC, the screen reports 'Controller 1: Comm Err'
Firstly, can I use the Beijer programming cable between the 2 units to establish comms?
This is my first use of either of these pieces of software.
SO I have set up the MELSEC FX Driver in the panel, using COM2 and I am using the SC-09 Beijer cable between the two devices.
The cable is good as I can download to the PLC, however, the screen does not want to talk to the PLC, the screen reports 'Controller 1: Comm Err'
Firstly, can I use the Beijer programming cable between the 2 units to establish comms?