saintmetal10
Member
Hello!
I am making a can crusher controlled by OMRON PLC. I have CJ1M CPU 12 and CPM2A CPU available. I prefer to work on CPM2A. I am new to OMRON PLCs and have many problems regarding programming in CX Programmer.
I have made this program attached here with the message. The problem I am getting is that, If I put a normally closed contact before a Delay Timer instruction as used in this program the timer keeps on counting over and over again and it does not energizes the coil attached to it in the next ladder.
Would be grateful for any kind of help as I'm really short on time.
I am making a can crusher controlled by OMRON PLC. I have CJ1M CPU 12 and CPM2A CPU available. I prefer to work on CPM2A. I am new to OMRON PLCs and have many problems regarding programming in CX Programmer.
I have made this program attached here with the message. The problem I am getting is that, If I put a normally closed contact before a Delay Timer instruction as used in this program the timer keeps on counting over and over again and it does not energizes the coil attached to it in the next ladder.
Would be grateful for any kind of help as I'm really short on time.
Last edited: