Hey everyone! It has been a while since I have had an issue to post about but here I am back to gather some knowledge from yall.
SLC5/05 talks to an desktop computer with VIA Ethernet to trend the kilns absorbing process. There is NO RSlogix on this computer just Rslinx. Now As you can see if this picture It SEES the plc and knows that it is there.
https://ibb.co/WBj4n0f
Now when I connect my laptop to the plc via Ethernet You get to see this
https://ibb.co/CB3nNZN
I have also tried to connect via 1747uic cable set up.
I am just not able to even see the device in RSLinx at all. Here is another picture of the plc using both ports of serial coms to the small hmi screen and rj45 ethernet to the pc.
https://ibb.co/kx4WmzW
Basicaly what I was doing was just removed the ethernet cable from the desktop and connecting my laptop.
SLC5/05 talks to an desktop computer with VIA Ethernet to trend the kilns absorbing process. There is NO RSlogix on this computer just Rslinx. Now As you can see if this picture It SEES the plc and knows that it is there.
https://ibb.co/WBj4n0f
Now when I connect my laptop to the plc via Ethernet You get to see this
https://ibb.co/CB3nNZN
I have also tried to connect via 1747uic cable set up.
I am just not able to even see the device in RSLinx at all. Here is another picture of the plc using both ports of serial coms to the small hmi screen and rj45 ethernet to the pc.
https://ibb.co/kx4WmzW
Basicaly what I was doing was just removed the ethernet cable from the desktop and connecting my laptop.
Last edited: