PLCrookiee
Member
Hi guys have only just been getting stuck into learning about PLC’s. I’ve got an older version of Studio 5000 and a CompactLogix PLC. I have connected a 0-10v transmitter across an input. In the ‘Controller tags’ section I’ve changed the ‘style’ for this input (Local 2:I. Ch1Data) from Binary to Decimal, however when I put in a ‘divide’ instruction and then use that tag it displays as Binary
I have tried right-clicking on the tag and editing the properties but the ‘style’ box at the bottom is grey and I cannot change
Not sure how to go about this one but any info would be much appreciated
I have tried right-clicking on the tag and editing the properties but the ‘style’ box at the bottom is grey and I cannot change
Not sure how to go about this one but any info would be much appreciated